U-Boot SPL 2017.11 (Dec 04 2017 - 12:31:11) DRAM: 512 MiB Trying to boot from MMC1 NOTICE: BL3-1: Running on H5 (1718) in SRAM A2 (@0x44000) NOTICE: Configuring SPC Controller NOTICE: BL3-1: v1.0(debug):aa75c8da415158a94b82a430b2b40000778e851f NOTICE: BL3-1: Built : 19:31:38, Oct 23 2017 INFO: BL3-1: Initializing runtime services INFO: BL3-1: Preparing for EL3 exit to normal world INFO: BL3-1: Next image address: 0x4a000000, SPSR: 0x3c9 U-Boot 2017.11 (Dec 04 2017 - 12:31:11 +0900) Allwinner Technology CPU: Allwinner H5 (SUN50I) Model: FriendlyARM NanoPi NEO 2 DRAM: 512 MiB MMC: SUNXI SD/MMC: 0 *** Warning - bad CRC, using default environment In: serial Out: serial Err: serial Net: No ethernet found. starting USB... No controllers found Hit any key to stop autoboot: 2  1  0 switch to partitions #0, OK mmc0 is current device Scanning mmc 0:1... Found U-Boot script /boot.scr reading /boot.scr 1005 bytes read in 24 ms (40 KiB/s) ## Executing script at 4fc00000 reading netbsd-SUNXI.ub 28423380 bytes read in 1648 ms (16.4 MiB/s) reading sun50i-h5-nanopi-neo2.dtb 14090 bytes read in 31 ms (443.4 KiB/s) libfdt fdt_path_offset() returned FDT_ERR_BADPATH ## Booting kernel from Legacy Image at 46000000 ... Image Name: NetBSD/sunxi 8.99.7 Image Type: ARM Linux Kernel Image (uncompressed) Data Size: 28423316 Bytes = 27.1 MiB Load Address: 40008000 Entry Point: 40008000 Verifying Checksum ... OK ERROR: Did not find a cmdline Flattened Device Tree Could not find a valid device tree SCRIPT FAILED: continuing... reading /sun50i-h5-nanopi-neo2.dtb 14090 bytes read in 32 ms (429.7 KiB/s) starting USB... No controllers found USB is stopped. Please issue 'usb start' first. starting USB... No controllers found No ethernet found. missing environment variable: pxeuuid missing environment variable: bootfile Retrieving file: pxelinux.cfg/00000000 No ethernet found. missing environment variable: bootfile Retrieving file: pxelinux.cfg/0000000 No ethernet found. missing environment variable: bootfile Retrieving file: pxelinux.cfg/000000 No ethernet found. missing environment variable: bootfile Retrieving file: pxelinux.cfg/00000 No ethernet found. missing environment variable: bootfile Retrieving file: pxelinux.cfg/0000 No ethernet found. missing environment variable: bootfile Retrieving file: pxelinux.cfg/000 No ethernet found. missing environment variable: bootfile Retrieving file: pxelinux.cfg/00 No ethernet found. missing environment variable: bootfile Retrieving file: pxelinux.cfg/0 No ethernet found. missing environment variable: bootfile Retrieving file: pxelinux.cfg/default-arm-sunxi No ethernet found. missing environment variable: bootfile Retrieving file: pxelinux.cfg/default-arm No ethernet found. missing environment variable: bootfile Retrieving file: pxelinux.cfg/default No ethernet found. Config file not found starting USB... No controllers found No ethernet found. No ethernet found. => boot switch to partitions #0, OK mmc0 is current device Scanning mmc 0:1... Found U-Boot script /boot.scr reading /boot.scr 1005 bytes read in 24 ms (40 KiB/s) ## Executing script at 4fc00000 reading netbsd-SUNXI.ub 28423380 bytes read in 1648 ms (16.4 MiB/s) reading sun50i-h5-nanopi-neo2.dtb 14090 bytes read in 31 ms (443.4 KiB/s) libfdt fdt_path_offset() returned FDT_ERR_BADPATH ## Booting kernel from Legacy Image at 46000000 ... Image Name: NetBSD/sunxi 8.99.7 Image Type: ARM Linux Kernel Image (uncompressed) Data Size: 28423316 Bytes = 27.1 MiB Load Address: 40008000 Entry Point: 40008000 Verifying Checksum ... OK ## Flattened Device Tree blob at 4fa00000 Booting using the fdt blob at 0x4fa00000 Loading Kernel Image ... OK Loading Device Tree to 0000000049ff9000, end 0000000049fff709 ... OK Starting kernel ... [ Kernel symbol table missing! ] Copyright (c) 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017 The NetBSD Foundation, Inc. All rights reserved. Copyright (c) 1982, 1986, 1989, 1991, 1993 The Regents of the University of California. All rights reserved. NetBSD 8.99.7 (SUNXI) #3: Mon Nov 27 09:39:44 JST 2017 root@trueos-610:/usr/home/mutoh/NetBSD/src/sys/arch/evbarm/compile/obj/SUNXI total memory = 512 MB avail memory = 479 MB armfdt0 (root) fdt0 at armfdt0: FriendlyARM NanoPi NEO 2 fdt1 at fdt0 fdt2 at fdt0 fdt3 at fdt0 cpus0 at fdt0 cpu0 at cpus0: Cortex-A53 r0p4 (Cortex V8A core) cpu0: DC enabled IC enabled WB disabled EABT branch prediction enabled cpu0: 32KB/64B 2-way L1 VIPT Instruction cache cpu0: 32KB/64B 4-way write-back-locking-C L1 PIPT Data cache cpu0: 512KB/64B 16-way write-through L2 PIPT Unified cache vfp0 at cpu0: NEON MPE (VFP 3.0+), rounding, NaN propagation, denormals cpu1 at cpus0: disabled (unresponsive) cpu2 at cpus0: disabled (unresponsive) cpu3 at cpus0: disabled (unresponsive) gic0 at fdt1: GIC armgic0 at gic0: Generic Interrupt Controller, 224 sources (215 valid) armgic0: 16 Priorities, 192 SPIs, 7 PPIs, 16 SGIs fclock0 at fdt2: 24000000 Hz fixed clock fclock1 at fdt2: 32768 Hz fixed clock fclock2 at fdt2: 16000000 Hz fixed clock gtmr0 at fdt0: Generic Timer armgtmr0 at gtmr0: ARMv7 Generic 64-bit Timer (24000 kHz) armgtmr0: interrupting on irq 27 sun8ih3ccu0 at fdt1: H3 CCU sun8ih3rccu0 at fdt1: H3 PRCM CCU sunxigpio0 at fdt1: PIO gpio0 at sunxigpio0: 94 pins sunxigpio0: interrupting on GIC irq 43 sunxigpio1 at fdt1: PIO gpio1 at sunxigpio1: 12 pins sunxigpio1: interrupting on GIC irq 77 fregulator0 at fdt0: vcc3v3 fregulator1 at fdt0: usb0-vbus fregulator2 at fdt0: gmac-3v3 sunxiusbphy0 at fdt1: USB PHY sun6idma0 at fdt1: DMA controller (12 channels) sun6idma0: interrupting on GIC irq 82 h3codec0 at fdt1: H3 Audio Codec (analog part) psci0 at fdt0: PSCI 0.2 gpioleds0 at fdt0: nanopi:green:pwr nanopi:blue:status /soc/syscon@1c00000 at fdt1 not configured sunximmc0 at fdt1: SD/MMC controller sunximmc0: interrupting on GIC irq 92 motg0 at fdt1: 'otg' mode not supported ehci0 at fdt1: EHCI ehci0: interrupting on GIC irq 104 ehci0: 1 companion controller, 1 port usb0 at ehci0: USB revision 2.0 ohci0 at fdt1: OHCI ohci0: interrupting on GIC irq 105 ohci0: OHCI version 1.0 usb1 at ohci0: USB revision 1.0 ehci1 at fdt1: EHCI ehci1: interrupting on GIC irq 110 ehci1: 1 companion controller, 1 port usb2 at ehci1: USB revision 2.0 ohci1 at fdt1: OHCI ohci1: interrupting on GIC irq 111 ohci1: OHCI version 1.0 usb3 at ohci1: USB revision 1.0 sunxitimer0 at fdt1: Timer sunxiwdt0 at fdt1: Watchdog sunxiwdt0: default watchdog period is 16 seconds com0 at fdt1: ns16550a, working fifo com0: console com0: interrupting on GIC irq 32 sunxirtc0 at fdt1: RTC sdmmc0 at sunximmc0 uhub0 at usb0: Generic (0000) EHCI root hub (0000), class 9/0, rev 2.00/1.00, addr 1 uhub1 at usb1: Generic (0000) OHCI root hub (0000), class 9/0, rev 1.00/1.00, addr 1 uhub2 at usb2: Generic (0000) EHCI root hub (0000), class 9/0, rev 2.00/1.00, addr 1 uhub3 at usb3: Generic (0000) OHCI root hub (0000), class 9/0, rev 1.00/1.00, addr 1 sdmmc0: SD card status: 4-bit, C4 ld0 at sdmmc0: <0x1b:0x534d:00000:0x10:0x078be7e7:0x0cc> ld0: 7523 MB, 3821 cyl, 64 head, 63 sec, 512 bytes/sect x 15407104 sectors ld0: 4-bit width, High-Speed/SDR25, 50.000 MHz boot device: ld0 root on ld0a dumps on ld0b root file system type: ffs kern.module.path=/stand/evbarm/8.99.7/modules WARNING: preposterous TOD clock time WARNING: using filesystem time WARNING: CHECK AND RESET THE DATE! Tue Sep 12 21:09:36 JST 2017 Starting root file system check: /dev/rld0a: file system is clean; not checking Not resizing /: already correct size swapctl: adding /dev/ld0b as swap device at priority 0 Starting file system checks: /dev/rld0e: 181 files, 496 free (124 clusters) Loaded entropy from /var/db/entropy-file. Setting tty flags. Setting sysctl variables: ddb.onpanic: 1 -> 0 Starting network. Hostname: rpi IPv6 mode: host Configuring network interfaces:. Adding interface aliases:. Waiting for DAD to complete for statically configured addresses... Starting dhcpcd. no valid interfaces found Building databases: dev, utmp, utmpx. wsconscfg: Cannot open `/dev/ttyEcfg': Device not configured wsconscfg: Cannot open `/dev/ttyEcfg': Device not configured wsconscfg: Cannot open `/dev/ttyEcfg': Device not configured wsconscfg: Cannot open `/dev/ttyEcfg': Device not configured Keyboard wsconsctl: WSKBDIO_SETENCODING: Permission denied Starting syslogd. Setting date via ntp. Sep 12 21:09:40 rpi ntpdate[228]: name server cannot be used: Temporary failure in name resolution (2) Exiting, name server cannot be used: Temporary failure in name resolution (2)/etc/rc.d/ntpdate exited with code 1 Mounting all file systems... Clearing temporary files. Updating fontconfig cache: done. Creating a.out runtime link editor directory cache. Checking quotas: done. Setting securelevel: kern.securelevel: 0 -> 1 Starting virecover. Checking for core dump... savecore: no core dump Starting devpubd. Starting local daemons:. Updating motd. Starting ntpd. Sep 12 21:09:43 rpi ntpd[406]: ntp_rlimit: Cannot set RLIMIT_STACK: Invalid argument Starting sshd. Starting inetd. Starting cron. The following components reported failures: /etc/rc.d/ntpdate See /var/run/rc.log for more information. Tue Sep 12 21:09:51 JST 2017 NetBSD/evbarm (rpi) (console) login: